AT

Autotransmit

AT

Command Group: Communication	Access:	Network interfaces:
	RW	CANopen
		MODbus
AT - Set autotransmit mode		PROFIbus

Synopsis:
	Command	Response
Get	AT	A<Value>
Set	AT <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	0	10
141.184	0	10
141.185	0	10
141.186	0	10
142.181	0	10
142.184	0	10
142.185	0	10
142.186	0	10
143.181	0	10
143.184	0	10
143.185	0	10
151.184	0	10
151.186	0	10
152.184	0	10
162.181	0	7
181.181	0	7
68.181	0	7

AT Set (or get) the auto transmit code.
This setting selects if the Device shall start in auto transmission mode upon power-up.
The values are:

Value DAD141 / DAD142 / DAD143 / LDB151 LDU68 / QLC162 / LDU181

0: IDLE (OFF, Factory Default). IDLE (OFF, Factory Default).

1: GROSS. GROSS.

2: NET. NET.

3: AVERAGE / DOSED. AVERAGE.

4: SAMPLE. PACKET.

5: LONG WEIGHT. SAMPLE.

6: PEAK. LONG WEIGHT.

7: HOLD. LONG AVG. WEIGHT.

8: VALLEY.

9: PEAK TO PEAK.

10: HBM AED.

Value	DAD141 / DAD142 / DAD143 / LDB151	LDU68 / QLC162 / LDU181
0:	IDLE (OFF, Factory Default).	IDLE (OFF, Factory Default).
1:	GROSS.	GROSS.
2:	NET.	NET.
3:	AVERAGE / DOSED.	AVERAGE.
4:	SAMPLE.	PACKET.
5:	LONG WEIGHT.	SAMPLE.
6:	PEAK.	LONG WEIGHT.
7:	HOLD.	LONG AVG. WEIGHT.
8:	VALLEY.
9:	PEAK TO PEAK.
10:	HBM AED.