TE

Trigger Edge

TE

Command Group: Checkweigher	Access:	Network interfaces:
	RW	CANopen	SDO2500sub02
		MODbus	2402,2
TE - Trigger Edge ^ selects rising or falling edge trigger		PROFIbus	read 38,2 write 38,130

Synopsis:
	Command	Response
Get	TE	E:<Value>
Set	TE <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	0	1
141.184	0	1
141.185	0	1
141.186	0	1
142.181	0	1
142.184	0	1
142.185	0	1
142.186	0	1
143.181	0	1
143.184	0	1
143.185	0	1
151.181	0	1
151.184	0	1
151.186	0	1
152.181	0	1
152.184	0	1
162.181	0	1
179.181	0	1
181.181	0	1
64.181	0	1
68.181	0	1
72.181	0	1
78.183	0	1
88.183	0	1

TE This command selects rising or falling slope trigger. TE = 0 select falling slope and TE = 1 select rising slope. Factory default setting: 0 (falling slope).
Note that TE only works on WCN122 when an input has been assigned as Trigger input.