PD20

Tare interval

PD20

Command Group: Filling	Access:	Network interfaces:
	RW	CANopen	SDO2200sub14
		MODbus	2326,2
PD20 - Set amount of cycles to pass before next tare		PROFIbus	read 6,20 write 6,148

Synopsis:
	Command	Response
Get	PD20	P20:<Value>
Set	PD20 <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.184	0	65535
142.184	0	65535
143.184	0	65535
151.184	0	65535
64.184	0	65535
88.184	0	65535

PD20 In some cases where the object being filled is not a new bottle, but say a box that is being emptied after each fill, the tare function is not necessary in every filling cycle. When parameter 20 is 0 (zero) taring only takes place in the very first filling cycle. When parameter 20 is 1 (one, default) the taring takes place in every filling cycle. Otherwise parameter 20 can be set to the number of filling cycles which have to occur before a tare measurement is taken again.