OM |
IO mask |
OM |
Command Group: DigitalIO | Access: | Network interfaces: | ||
RW | CANopen | SDO2100sub0C | ||
MODbus | 2116,2 | |||
OM - Set the IO mask. | PROFIbus | read 18,12 write 31,12 |
|
|
OM In order to control the outputs from the host application the outputs must be configured using the OM command. A “1” bit in the mask will open the corresponding output channel for outputs from the IO command and a “0” bit will leave the channel controlled by the setpoint.
Issuing the OM command without any parameters returns the current mask in the form OM:0011.
Change the mask by issuing the IM command with the appropriate four-digit value in the form OM 0001.
NOTE: This command is called IM on other H&B devices.